mode rejection
英 [məʊd rɪ'dʒekʃ(ə)n]
美 [moʊd rɪ'dʒekʃ(ə)n]
模式抑制
双语例句
- Normal mode rejection ratio ( NMRR) defines how well the instrument rejects or attenuates noise that appears between the HI and LO input terminals.
串模抑制比（NMRR）说明了仪器抑制或衰减高、低输入端之间出现的噪声的能力。 - The design of the common mode rejection performance in the isolated computer-controlled multichannel ECG systems
计算机控制的多导心电隔离测量系统的共模抑制性能设计 - Owing to weak output signals integrated amplifier is designed, which is characteristics of shorter wires, higher input impedance, higher common mode rejection ratio and series mode rejection ratio, smaller zero shift and temperature shift.
由于输出信号微弱，采用短线路传输，高输入阻抗，共模抑制比和串模抑制比高，温漂和零漂小的集成运放电路。 - In addition, the systematic error could be adjusted by the regression mode so that the rejection and waste caused by systematic error could be avoided.
利用回归模型校正系统误差，避免因系统误差引起不必要的调查返工所造成的人力和物力资源浪费。 - On the foundation of chapter three, double-period inventory module and multi-period inventory module of period replenish in the mode of goods rejection have been studied in chapter four, the conclusion of which is a series of signal marginal values without fixed cost for replenish.
第四章在第三章的基础上研究了顾客退货模式下周期盘点的两周期和多周期库存模型，其结论为一组单临界值；3.研究了多周期库存问题中集中库存策略的应用。 - Based on the structure, an ultra-low voltage operational amplifier is designed, which provides a rail-to-rail common-mode input voltage range and output voltage swing, as well as a high common mode rejection ratio ( CMRR).
基于此结构，实现了一种超低压运算放大器。仿真分析表明，该运算放大器能够实现轨到轨（rail-to-rail）的共模输入电压范围和输出电压摆幅，以及较高的共模抑制比。 - Simulation shows that the power supply rejection ratio ( PSRR) of the circuit has been greatly improved, and high common mode rejection ration ( CMRR) has been achieved for the cascode OTA.
该设计提高了电源抑制比（PSRR），并具有较高的共模抑制比（CMRR）。 - Experimental results show that the device can precisely measure many parameters of IOA, such as input offset voltage, input offset current, open loop differential AC voltage gain and AC common mode rejection ratio.
实验结果表明该测试仪能准确测量运算放大器的输入失调电压、输入失调电流、交流差模开环电压增益和交流共模抑制比等参数。 - The equivalent input noise voltage, offset voltage drift, common mode rejection, power source rejection and other characteristics of a common source-common grid cascade amplifier is analysed in detail.
本文对一种共源-共栅串接差分输入级运算放大器的等效输入噪声电压、失调电压温漂、共模抑制比和电源电压抑制比等参数进行了详细的分析。 - ABSTRACT This paper deals with theoretical and practical problems concerning the design of the common mode rejection performance in the isolated computer-controlled multichannel ECG systems.
本文讨论计算机控制的多导心电隔离测量系统共模抑制性能设计的理论和实际问题。 - To measure the fluid with low conductivity, it is necessary to resolve the problems of impedance conversion, the stability of the reference point of signal, signal transmission, and common mode inter-ference rejection.
测量低电导率流体的流量要解决的问题有测量仪表的阻抗转换、信号基准点的稳定、信号传输以及共模干扰的抑制等。本文讨论了电磁流量计测量流体电导率的下限值； - Chapter five introduces the theory of multi-echelon inventory, with initiative discussion on multi-echelon inventory control of period replenish in the mode of goods rejection.
第五章介绍了多级库存的理论，初步探讨了顾客退货模式下周期盘点的多级库存的控制问题。 - By means of applied technology of IC operational amplifiers, digital to analog converter and single chip microcontroller, a programmable precision measuring differential amplifier with low noise, low drift, high input impedance and high common mode rejection ratio is developed and introduced.
介绍了一种由DAC电压衰减器作为集成运放反馈电路的低噪声、低漂移、高输入阻抗和高共模抑制比的可编程精密差动测量放大器。 - On the Relation Between Power Source Rejection Ratio, Open Loop Voltage Gain and Common Mode Rejection Ratio of an Operational Amplifier
运算放大器电源电压抑制比、开环电压增益和共模抑制比的关系 - The common mode rejection technique is valid for rejecting a variety of noises. Surface profile and roughness parameters of sample are simultaneously displayed.
利用干涉共模抑制技术，有效抑制了各种噪声，测量数据可靠； - And gain, common mode rejection ration in folded cascade amplifier.
折叠共源共栅放大器的增益、共模抑制比等。 - The pretreatment circuit contains mainly four parts, they are the fore-end protect circuit, radio frequency filter, middle amplification circuit, common mode rejection circuit and back-end amplification circuit. 2.
预处理电路主要包括：前端保护电路及滤波器、中间级放大电路、共模抑制电路以及后端放大电路四个部分。 - The active mode of project payment is rejection/ acceptance in our country.
我国现行的工程支付方式仍然是拒绝/接受程序，对工程质量的评价只是合格或者不合格。 - Signal amplification system designed partly based on the differential op amp amplifier circuit to improve the signal to noise ratio, increasing the signal common mode rejection ratio.
系统的信号放大设计部分采用了差分运放放大电路，以提高信号的信噪比，并增大信号的共模抑制比。 - Analog front-end circuit consists of preamplifier, low pass filter circuit and back stage amplifier circuit, preamplifier circuit instrumentation amplifier is used because it has a high input impedance, high common mode rejection ratio ( CMRR), low noise, and low drift.
模拟前端电路由前置放大电路、高低通滤波电路和后级放大电路组成，前置放大电路用的是仪表放大器，因为它有高输入阻抗、高共模抑制比（CMRR）、低噪声、低漂移。 - Under reverse and zero bias, the PD works in depletion mode with low dark current and high UV/ visible rejection ratio.
在反偏和零偏下，器件工作在耗尽模式，表现出低的暗电流和高的紫外/可见抑制比。 - On this basis, the improved SVPWM modulation strategy and the common mode rejection filter are discussed and comparison.
在此基础上，研究了改进SVPWM调制策略与共模抑制滤波电路对共模漏电流抑制原理。 - And show on the professional development training mode rejection, boredom.
并表现出对目前专业成长培养模式的排斥、厌倦。 - Ability to collect high accuracy, high input impedance and high common mode rejection ratio of the technical parameters, making the system more reliable results reflect the true acquisition.
高精度的采集能力，高输入阻抗和高共模抑制比的技术参数，使得系统能更可靠的反映真实采集结果。